Home > Accessories > RadioShack Accessories >

SpectrumForce Desk Mount for Four Base Scanners
Desk Mount for Four Base Scanners
 
MSRP: $99.95
Our Price: $74.95
You Save: $25.00

Stock Status: In Stock


Product Code: 01-531337
Qty:

Basics
 
This 4-scanner Desk Mount, built with strong sheet-metal, allows you to attractively mount and display between one and four base or base/mobile scanners that are approximately 7 to 7.5" wide. You can mount any combination of the following Uniden Bearcat Scanners: BCD996P2, BCD536HP,SD200 ,760, 780, 785, 796, BCT15, BCD996T; GRE PSR400 and PSR600; and a variety of Radio Shack models including the 2053 and 2096 and similar models.

You can also drill holes in the bottom flanges to secure the mounting bracket to a desk or table but the radio weight keeps the unit from sliding in general. You can tilt the radios slightly upward for easy of operation if you desire. The front of the radios protrude approximately 1/2" from the edge of the metal providing a very strong and again, professional, appearance. Simply use the mobile mounting knobs (or bolts can easily be found at a local hardware store) to secure the scanners in place. These brackets are being used at news media assignment desks nationally as well as by hobbyists as a clean and attractive way to present and operate the radios. The brackets have been black-powder-coated to add to the professional look. The mount fits radios of 7.5" perfectly such as the DIN-E radios: The BCT15, BCD996T, PRO-2096, PSR400 and PSR600. But earlier scanners that are 7" wide will require the addition of a few washers or a nut. A two-high and a three-high version are also available.

The dimensions are as follows: 7.5" wide (inside) by 6 1/8" deep by 12" high; the flange at the bottom is 1" wide.

Average Customer Review: Average Customer Review: 4.5 of 5 4.5 of 5 Total Reviews: 4 Write a review.

  2 of 2 people found the following review helpful:
 
3 of 5 Great-Except one serious flaw February 10, 2021
Reviewer: Charles Augat from Mashpee, MA United States  
Performs excellent with 996 size radios. Not that well with the SDS200.  The volume and squelch control, being mounted on the right side of the radio, do not allow enough room to easily be used.  The two controls are only .50 from the wall of the mount and are recessed to deep making for a very tight finger fit

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 Excellent Build Quality May 19, 2020
Reviewer: Mike from Ocean County, NJ United States  
I ordered this for the current 3 base unit scanners I have... the footprint is great and it is sturdy. Had everything mounted in less than 10 minutes. This is a highly recommended space saver!

Was this review helpful to you?

  2 of 2 people found the following review helpful:
 
5 of 5 The Best! December 30, 2014
Reviewer: Anonymous Person from MA United States  
If you need a place to mount your scanners, look no further, you have found the best! So go ahead and order, you won't be disappointed!

Was this review helpful to you?

  1 of 1 people found the following review helpful:
 
5 of 5 SpectrumForce Desk Mount for Four Base Scanners April 2, 2014
Reviewer: Jimmy Blue from Teaneck, NJ United States  
An excellent multy unit mount but a bit pricey. Would be nice to see these priced a bit lower for what it is.

Was this review helpful to you?